28.02.2023

Refilling the Ricoh Aficio SP100 cartridge. Ricoh Aficio SP100 Cartridge Refill Ricoh Aficio SP100 Cartridge Refill


By following all precautions and having all the necessary tools at hand, you can easily refill your cartridge. Ricoh Aficio SP100, you just need to purchase the original Ricoh toner at Omskaya, 82.

1. Preparation for refueling

For cartridge refills Ricoh Aficio SP100 You will need original toner. As auxiliary tools, you will need scissors, a funnel and a slotted screwdriver. As an additional protection against inhalation of fine particles of toner, it is better to fill the cartridge with a mask or respirator using thin rubber gloves.

For high-quality cleaning of the cartridge waste bin from waste toner waste, it is necessary to use a special vacuum cleaner with a HEPA filter, an ordinary household vacuum cleaner is not designed for this.

2. Cartridge refillingRicohSP100

2.1. Waste bin cleaning

Use a slotted screwdriver to open the oval cover in the waste bin.

Remove the waste toner through the hole.

Close the waste toner hole with the cap.

2.2. Preparing to refill the cartridge

Open the round cover in the hopper with a screwdriver. It is usually sealed initially with a Ricoh warranty seal.

The round cap of the filling hole is made of soft plastic, so you should not exert much effort and mechanical stress, so as not to damage it.

The packaging with the original toner is opened with scissors.

When cleaning and refilling the cartridge, be careful not to damage the photoconductor.

2.3. Refilling with toner powder

Filling the cartridge with toner powder will be much easier if you fill the toner with a funnel.

Close the hole with a cap.

The manufacturer claims that acceptable print quality will be maintained when the cartridge is refilled no more than 2 times. However, the quality of printouts may decrease slightly due to natural mechanical wear of the photoconductor.

The Ricoh printer or MFP warranty is valid only if the cartridges are refilled with original Ricoh toner.

To the device Ricoh Aficio SP100 suitable cartridges: We also repair the Ricoh Aficio SP100 MFP

Refill cartridges for Ricoh Aficio SP100

Delivery, departure.

If the order is placed before 14:00, we can arrive on the same day. Refueling is carried out in front of you, we usually do not pick up cartridges. It is more convenient both for us (no need to travel once again) and for you (after refueling, you can immediately check the work). And, of course, such a system of work is faster - you won’t have to wait long until the device starts working again. The cartridge ran out, you shook it, called us and after a maximum of 4 hours everything is working for you.

Payment.

We accept payment both in cash and by bank transfer. There is no need to make an advance payment, we trust our customers. Just call, we arrive, do the work and leave, leaving a receipt. After our operator will contact you, take the details. We will make a complete set of documents and bring it by courier.

Ricoh has released a series of printers and MFPs for home and small office that compare favorably with competitors in several ways.

The new series was named sp100 and included three devices at once:

The Aficio™SP 100SF is the top of the line device and contains everything you need for a home office. The MFP, despite its small size, is equipped with an ADF module and has four main functions: print, scan, copy, fax. The fax machine is capable of receiving up to one hundred sheets in memory and has a speed dial memory of up to 100 numbers. The lack of network functions prevents the machine from performing Network Scan to Folder.

The Aficio™SP 100SU is a stripped down version of the top MFP. They cut down, first of all, the fax function, and with it the automatic document feeder. In principle, this is not so scary, given that in our time the fax is gradually fading into the background. Due to the fact that some of the functions have been cut, today the MFP SP 100SU turned out the most compact and inexpensive MFP in the world. The price reduction affected the quality of scanning - only 600 × 600 dpi, which, in principle, is enough for scanning and copying documents.


Aficio™SP 100 is simply a compact laser printer with a record low price.
All models have a passive cooling system and practically do not produce noise during operation. True, because of this, the printer warm-up time has increased to 30 seconds, but the peak power consumption has decreased to 250W, the closest competitor Panasonic KX-MB1500 has a peak power consumption of 950W.

Refilling Ricoh sp100 cartridges

Ricoh has taken a step towards users and released a series of devices with officially authorized refilling cartridges, moreover, it even sells toner for refilling cartridges. The toner is sold as a pack and has the Ricoh part number 407062. The refill of the Ricoh sp100 cartridge is designed for 2000 copies. Unlike the Xerox 3100, the Ricoh sp100 devices do not have any smart cards or other nasty things that artificially limit the life of the cartridge. An essential advantage of Ricoh sp100 cartridges is their design, Ricoh engineers not only made a plug for filling the toner, but also made stopper for shaking out mining !!!Refilling the cartridge is quite simple:
a) Open the cap on the toner tank (round cap), pour the toner into the hole and close the cap.
b) Open the cap on the waste hopper (rectangular cap), shake out the waste toner and close the cap.
For those who still experience difficulties, you can peep into the official brochure of Ricoh engineers on refilling cartridges here at this link.

For refueling, it is not necessary to run around and look for toner all over the city; ordinary toner from Samsung monochrome printers is suitable for refilling a cartridge. The highest quality print without background, stripes, blots and other artifacts was given by polyester toners (Polyester toner).

Refilling chipped cartridges Ricoh Aficio SP100 (version for Ukraine)

All of the above is relevant for Russia, but in Ukraine, Ricoh Aficio SP100 are sold already chipped. But this is not a problem for refilling the cartridge, it is enough to flash it with this firmware. The diagram of connecting the programmer to the chip can be seen from the photo on the left (click to enlarge). The chip is based on a 5ME3 chip and any JDM type programmer can be used for firmware, IC-PROG or PonyProg can be used as a program, in the program settings when flashing, you need to specify the chip type 24c01. After flashing the chip, the cartridge can be refilled, just like the Russian version of Aficio sp100.

Conclusion

Technically, Ricoh has created a small revolution, a printer that can be refilled by the user without going to a service center, it's more like a fairy tale that has come true. Despite the fact that the cartridge does not look reliable, unlike the Samsung 1660/2160, the drum cartridge uses a normal diameter as in the hp 1010, which in turn will allow you to refill the cartridge much more than 2 times recommended by Ricoh. Of the shortcomings, only a small paper tray of only 50 sheets and a low print speed of only 13 pages per minute can be distinguished, but for a home printer these shortcomings are not critical.

So, you have become the proud owner of a Ricoh SP 100SU MFP or a Ricoh Aficio SP 100 printer. This note still describes how the Ricoh SP 100SU cartridge is refilled, however, as far as I understand, they have the same type of cartridges, so it’s suitable for both.

Before a direct description, I will make a reservation that when refueling, I personally use collective farm methods with improvised tools in haste and as a toner I use a standard toner for Samsung ML-1210/1520/1610/1640/1660/1710/2010/SCX-4 × 00/3200 kilogram canister, which is also suitable for refilling the Xerox P8E. Of course, I must tell you that it’s better to buy original cartridges and, in case of refilling, use only original Ricoh toners, but we understand that cartridges cost half, or even 2/3 of the device itself, and you need to look for original toners somewhere .

In general, I will not waste your time, let's move on to the gas station. You will need (ideally): gloves, a mask, a slotted (flat) screwdriver, a funnel (you can roll a cap with a hole from A4 sheet), a couple of bags for working out, napkins or rags for wiping the place of work and the cartridge itself, toner and cartridge. A mask will be required in order not to inhale particles of toner (you can just pull a T-shirt over your face), and gloves so as not to get your hands dirty.

So, we prepare the bag for working off, pry off the cap and uncork the waste toner bin with a screwdriver:

We turn the hole over into the prepared bag and shake out all the insides into it (if in the process it seems to you that everything is already there, believe the toner is still inside, shake it and shake out the remnants). When you are sure that there is nothing left inside, it is recommended to vacuum the inside with a special vacuum cleaner (which you, like me, most likely do not have) or blow it with compressed air (do not under any circumstances do this indoors!), so we return the lid of the hopper with working into place and wipe the cartridge.

Now open the round cap for filling:

Before falling asleep, it is better to install the cartridge with a slight slope so that the side with the hole where you pour the toner is 30 degrees higher (it is not necessary to use a protractor, the figure is taken from the ceiling). Now we insert a funnel or an alternative device and start pouring the toner into the hole (you need about 80 grams). Do not be afraid to fall asleep a little less, it is better to "overdo" than "underdo". Gently tap on the cartridge so that the toner is poured into the hopper, close the lid, wipe the cartridge and insert it back into the MFP / printer (I recommend shaking the cartridge a little beforehand). Don't forget to clean up after yourself. Everything, you can continue printing (I usually run a couple of test pages after refueling).

The Ricoh SP 101E cartridge is suitable for Ricoh Aficio , . It is officially allowed to refill this cartridge with original Ricoh toner. However, the guarantee remains in effect. Samsung ML-1210 toner is also suitable.

For Russia, Ricoh SP 101E is supplied without a chip, for Ukraine - with a chip. You will either have to reflash or look for compatible chips. For flashing, you can contact the service center. You can fill up yourself.

Tools

For refueling we need:

  • toner (or original or Samsung ML-1210);
  • disposable gloves (available at the nearest supermarket);
  • medical mask (you can buy at the pharmacy along with gloves);
  • a watering can (or a sheet of paper with tape to make a watering can yourself);
  • waste toner bag;
  • straight screwdriver.

Gloves are optional - you can wash your hands afterwards. The mask is required (adds +3 to health).

Refueling

  1. We take out the cartridge from the device.
  2. We put on a mask and gloves.

    With a straight screwdriver, open the lid of the bunker with mining.

  1. Pour the contents into the package. If it is possible to blow it with compressed air, we blow it outside. We close the bunker with mining.
  2. Open the filling hole with a straight screwdriver.

  1. Tilt the cartridge approximately 30°. You can put something under the side with the filling hole.

  1. If there is a watering can, insert it into the filling hole. If not, we make it from a piece of paper and tape and insert it into the hole.
  2. Open the toner package. You can use scissors or a knife to get a cut of 15-20 mm.

    Carefully pour the toner into the funnel. 80 g in the original pack.

Tapping lightly on the funnel with a screwdriver, wait until the toner enters the hopper.

  1. Close the filling hole. Use a cloth to remove the remaining toner from the cartridge and shake the latter.

You can work.

Video




Print with pleasure.


2023
maccase.ru - Android. Brands. Iron. News